Vent Axia Sentinal Kinetic B/BH

Features & Benefits

• Low Carbon MVHR unit

• Recognised in SAP Appendix Q

• Ultra quiet

• Lightweight for easier installation

• Horizontal duct option for space-saving installations

• Fits within a 290mm deep kitchen cupboard

• Integrated digital controller for simple and accurate commissioning

• Integral humidistat

• BMS connectivity

• LS inputs/(Light Switch) and volt-free inputs

• Self diagnosis for simplified fault finding

• Adjustable delay On/delay Off timer

   

Easy Installation

The Sentinel Kinetic models can be mounted vertically in a roof space, hallway cupboard or kitchen or within a kitchen cupboard. When mounted in an unheated area ducting should be insulated. Ducting can be attached to the unit horizontally, vertically or both. Minimum internal depth of kitchen cupboard: B & BH models 290mm.

V&B/BH Spigot Options

Left (L) or right (R) hand installation. The unit is supplied with duct spigots to outside on the right hand side. These can be reversed on site by simply removing the control panel, rotating the unit 180 degrees and re-attaching the control panel. Horizontal and vertical spigots: The combination of spigot options allows installation in confined locations. If vertical and horizontal connection is required on the same outlet/inlet, additional spigots can be supplied.

The condensate drain can be taken out through the back, side or bottom of the unit. Using the fittings supplied, the final condensate connection is
made outside the unit and can be completed after installation.

Integral Humidity Sensor

The integral humidity sensor increases speed in proportion to relative humidity levels, saving energy and reducing noise. The sensor also reacts to small but rapid increases in humidity, even if the normal trigger threshold is not reached. This unique feature ensures adequate ventilation, even for the smallest wet room. The night time relative humidity setback feature suppresses nuisance tripping as humidity gradually increases with falling temperature.

Controllers

441865 - Wireless enable kit (includes receiver and 1 controller)

The wireless enable kit allows the Kinetic to be set to boost or purge from a remote wireless controller. One wireless controller is supplied with the kit. Up to three additional controllers may be linked to the wireless receiver.

437827 - Additional Wireless boost switch

443283 - Wired remote controller (includes 15m cable)

The Kinetic wired remote controller duplicates all the functions of the on-board controller allowing the unit to be commissioned, controlled and monitored remotely. The controller is supplied with 15 metres of four core cable fitted with an RJ11 plug for fitting to the Kinetic control pcb. Flush mounting, suitable for a single gang patress box 16mm deep.

455213 - Normal Boost Switch

A single gang switch to boost from high to low speeds on all heat recovery units.

Accessories

441774 - Pollen Filter (Pack of 2)

Replacement filter set comprising 2 filters for the Kinetic B/BH unit.

444200 - F5 Filter (1 supplied)

Replacement filter comprising one supply filter for the Kinetic B/BH unit. Pack contains one F5 Pollen filter. F5 provides increased performance filtering out most pollens.